Display Messages - Felix printers Pro L Quick Start Manual

16 Display messages

Firmware requested pause/filament jam detected
The flow detection system is triggered – the printer moves to its idle position waiting for user action.
The flow detection system is triggered when there is no more filament going through the extruder or when the filament is not
extruding at the expected rate. Go to www.felixprinters.com/support to learn more.
Z-sensor error/refusing to home
The z-sensor triggered message should appear only when the tip of the hot-end touches the print bed.
If the message is displayed continuously go to www.felixprinters.com/support to find out how to solve this issue.
Heater sensor error
Extruder: the sensor is defective or not connected properly. Please check if the connector is placed correctly and is clean on the
inside.
Heated bed: The bed temperature sensor circuit is defective . That can mean the temperature sensor, or the wiring of this sensor.
Heater error
Extruder: the heater or sensor are giving improper values. Please check if the connector is placed correctly and is clean on the inside.
Heated bed: please check if the contact pins under the bed look ok.
Leveling failed
The z-sensor triggered falsely during the leveling routine or measured probe values are out of their boundaries.
Go to www.felixprinters.com/support and look for the 'z-sensor triggered' topic.
Page 34
Quick Start Guide FELIX Pro L / XL