Table of Contents
Advertisement
( ) Install the ceramic standoff insulators on the
screws of the final tank coil
(#40-548)
as
shown. Do not overtighten the insulators.
( ) Discard the small screw and one of the flat
washers that were supplied with each ce-
ramic standoff insulator.
Refer to Detail 3-3F for the following steps.
Wire from lug 1 through hole 20.
Wire from
lug
2 through hole 21.
Wire from
lug
3 through hole 22.
Wire from
lug
4 through hole 23.
( ) Position
the wires
from
capacitor
T A
through the following holes, and install the
variable capacitor at
T A
with a #6 solder
lug on the bottom of the chassis
at
Z as
shown in Detail 3-3E. Use 6-32
x
1/4"
screws and #6 Iockwasher s,
Detail 3-3F
REAR
OF
CHASSIS
STANDOFF
SC RE W
STANDOFF
I
FLAT
WASHER~
I
. :.
.
.
. . .
',
,:;:.
..".
&<\
.
:.,
.:
.
.
.:.
( ) 2-3
/4" to lug 1 (8-1).
(
) 2" to lug 2 (8-1).
(
) 5" to lug 3 (8-1).
( ) 4:' to lug 4 (S-l).
Connect one end of the following lengths of red
stranded wire (heavy insulation) to this 4-section
variable capacitor. Position the wires as shown.
CAUTION: Keep the plates of all variable ca-
pacitors closed at all times to prevent damage
to the capacitor plates.
( ) Bend all eight lugs of the 4-section variable
capacitor (#26-74)
as
shown.
Refer to Detail 3-3E for the following steps.
Detail 3-3E
Page 26
Hide quick links:
Advertisement
Table of Contents
