Final Assembl Y - Heathkit SB-401 Assembly Manual

Page 103
( ) Carefully peel away the backing paper from
the blue and white label. Then press the
label onto the side
of
the chassis or other
location where it can easily be referred
to.
NOTE: The blue and white identification label
shows the Model Number and Production Series
Number of your kit. Refer to these numbers in
any communications with the Heath Company;
this assures you that you will receive the most
complete and up-to-date information in return.
Figure 3-1
CHASSIS
#6 LOCKWASHER
®
6-32 NUT®
\
LONG ANGLE BRACKET
(#204-M5S0)
6-32x3/S" '-
FLAT HEAD SCREW
HEA.T~K:rT®
( ) Install the 8-32 x 1/4" nickel screws into
the front-side holes of the cabinet.
( ) Install rubber feet and 3 /4" to 1" tapered
spacers at the front corners of the cabinet,
using 6-32 x 1_1/2" screws and #6 flat
washers. NOTE: Extra 6-32 x 3/4" screws
are supplied so that the spacers may be
eliminated
if
desired.
( ) Carefully turn the chassis and cabinet over
and install a rubber foot at each rear corner
using 6-32 x 3/4" screws and #6 flat
washers. The screws fit through the cabinet
holes into the threaded holes in the chassis.
Refer to Figure 3-2 for the following steps.
( ) Turn the chassis over and slide it into the
cabinet from the front.
Refer to Figure 3-1, and install the long
angle brackets, using 6-32 x 3/8" flat head
hardware.
( )
BLY
FINAL ASSE