Adjusting The Charging Voltage - Soyer BMS-9 Operating Instructions Manual

11.1.2 Adjusting the charging voltage

The charging voltage has been preset (see chapter "11.1.1 Device adjustment tables"
on page 39). A value for the charging voltage is proposed depending on the selected
diameter and gun type recognised by the device.
Step 1:
Step 2:
Step 3:
The charging voltage is adjusted.
The set value is saved and remains unchanged after the device has been
switched off and back on again.
Connect the device as described in chapter "10.2 Connection of
the stud welding device and the stud welding guns" on page 36.
Preselect the required stud
diameter.
A value for the charging
voltage in [V] is shown on the
display.
The value may be increased or
decreased by pressing the
arrow keys ↑↓.
Operating instructions Soyer Bolzenschweißtechnik 41