Soyer BMS-9 Operating Instructions Manual page 34

Installing adjustable stud chucks
Step 6:
Step 7:
Step 8:
Step 9:
The assembly is complete.
34
Slide the stud chuck up to the stop into
the spring piston of the gun.
Hand-tighten the union nut.
Plug the support tube onto the gun.
Insert a stud and check the stud
protrusion.
The stud/stud flange must protrude 1.5 –
3 mm from the support tube.
If applicable, correct the setting of the
stud chuck (see chapter "Adjusting the
stud chuck" on page 32).
Operating instructions Soyer Bolzenschweißtechnik