Soyer BMS-9 Operating Instructions Manual page 43

Adjusting the lift time/height of lift
Step 4:
To activate the "Setup" mode, press
down the ↑↓ keys and switch on the
stud welding device at the same
time.
Keep the arrow keys pressed down
until "L- -" is shown on the display.
"66" or "99" is shown on the display if an incorrect key combination
was pressed. To reset the error, switch the device off and on again
using the main switch.
After approx. 1 second the gun type recognised by the device is shown on the display.
WARNING
"Setup" mode is only activated when
- the gun type is shown on the display
- the ready indicator lamp does not light up
- no stud preselection is lit.
A gap welding gun with lifting magnets not recognised as being PS-9 is
automatically shown as being a PS-3 gun.
If all three criteria are not satisfied, you are in the operating mode and a weld
is carried out the next time the release button is pressed.
Step 5: Place the gun on the workpiece and press the release
button on the gun for the weld.
Make sure the "Stud on workpiece" blue control lamp lights up before
triggering.
The currently set value for the lift time in [ms] appears on the display.
The longer the lift time, the higher the height of lift. Determining the
correct lift time requires experience and some trials. Guide values for
the correct lift time can be found in chapter "11.1.1 Device adjustment
tables" on page 39.
The lift time is changed using the adjustment ring on the welding gun for
the height of lift of the stud.
When the required lift time is set, switch off the stud welding device and then back
on again. The device is then back in the operating mode.
Operating instructions Soyer Bolzenschweißtechnik
Activating the "Setup" mode
and
43