Installing The Driver In A New System With Windows 95 (Oem Sr2 - Version 95B); Installing The Driver In A New System With Windows 95 - Adaptec 2025ZCR Installation Manual

Installing the Driver in a New System with Windows 95

(OEM SR2 – Version 95B)
In this scenario, you are installing a bootable Adaptec RAID
controller in a new system with Windows 95 (OEM SR2 version).
Note: If your version of Windows predates SR2, you must
install windows and upgrade to SR2 before installing the
Adaptec RAID controller.
To install the driver
1
Install and configure your Adaptec RAID controller and hard
drives according to the instructions in
2
Start up the system. During startup, press Ctrl+A to start
SMOR. Use SMOR to create the RAID. For details, refer to
Using SMOR on page
3
Shut down the system and restart from a bootable DOS disk.
4
Run
fdisk
size.
5
Mark the primary DOS partition Active.
6
Restart the system from the DOS disk.
7
Perform a system format by typing format c: \s.
8
Remove the DOS disk and insert the driver disk you created
earlier (refer to
9
Remove the driver disk.
10
Restart the system.
11
Insert the Windows 95 OEM SR2 CD.
12
Type d:\setup where d: is the letter assigned to your CD
drive.
13
Follow the Windows installation prompts. When Windows is
fully installed, proceed to the next step.
2-11.
and create a primary DOS partition of an appropriate
page 3-11).
Installing the Driver
Chapter 2.
3-15