Advertisement
Operation
Stopping the engine
NOTICE: Stopping the engine immediately after it has
been working under load can result in overheating and
accelerated wear of the engine components. If the en-
gine has been working at high loads it is important that
the engine is run at low idle for at least three minutes to
reduce and stabilise internal engine temperature before it
is stopped. Avoiding hot engine shutdowns will maximise
turbocharger shaft and bearing life.
NOTICE: Emergency shutoff controls are for EMERGEN-
CY use ONLY. DO NOT use emergency shutoff devices or
controls for normal stopping procedure.
1. Press the Main Power button OFF
2. Turn the key to the OFF position.
OK
OK
OFF
ON
OFF
ON
OFF
ON
Grinding
Speed
OFF
ON
On
Main Power
Off
Warning
HTC 2500 iX
2
1
3. The engine will run at idle and stops automatically after
two minutes in order to stabilise internal engine temperature
and maximise turbocharger life.
4. Make sure that diesel engine is complete stopped.
5. Turn the Main Power switch to OFF and remove the key.
OK
OK
OFF
ON
OFF
ON
OFF
ON
Grinding
Speed
OFF
ON
On
Main Power
Off
Warning
HTC 2500 iX
45
Advertisement
Chapters
