Advertisement
60
Maintenance Section
Driven Equipment - Check
Illustration 32
Cooling system filler cap
Pressurized System: Hot coolant can cause seri-
ous burns. To open the cooling system filler cap,
stop the engine and wait until the cooling system
components are cool. Loosen the cooling system
pressure cap slowly in order to relieve the pres-
sure.
1. Remove the cooling system filler cap slowly in
order to relieve pressure.
2. Maintain the coolant level within 13 mm (0.5 inch)
of the bottom of the filler pipe. If the engine is
equipped with a sight glass, maintain the coolant
level to the correct level in the sight glass.
3. Clean the cooling system filler cap and inspect the
gasket. If the gasket is damaged, discard the old
filler cap and install a new filler cap. If the gasket
is not damaged, use a suitable pressurizing pump
in order to pressure test the filler cap. The correct
pressure is stamped on the face of the filler cap. If
the filler cap does not retain the correct pressure,
install a new filler cap.
4. Inspect the cooling system for leaks.
Driven Equipment - Check
Refer to the OEM specifications for more information
on the following maintenance recommendations for
the driven equipment:
•
Inspection
•
Adjustment
This document is printed from SPI². Not for Resale.
•
Lubrication
•
Other maintenance recommendations
Perform any maintenance for the driven equipment
which is recommended by the OEM.
Engine - Clean
g00285520
Personal injury or death can result from high volt-
age.
Moisture can create paths of electrical conductiv-
ity.
Make sure that the electrical system is OFF. Lock
out the starting controls and tag the controls "DO
NOT OPERATE".
Accumulated grease and oil on an engine is a fire haz-
ard. Keep the engine clean. Remove debris and fluid
spills whenever a significant quantity accumulates on
the engine.
Failure to protect some engine components from
washing may make your engine warranty invalid.
Allow the engine to cool for one hour before washing
the engine.
Periodic cleaning of the engine is recommended.
Steam cleaning the engine will remove accumulated
oil and grease. A clean engine provides the following
benefits:
•
Easy detection of fluid leaks
•
Maximum heat transfer characteristics
i00174798
•
Ease of maintenance
Note: Caution must be used in order to prevent
electrical components from being damaged by
excessive water when the engine is cleaned.
Pressure washers and steam cleaners should not be
directed at any electrical connectors or the junction of
cables into the rear of the connectors. Avoid electrical
components such as the alternator and the starter.
Protect the fuel injection pump from fluids in order
to wash the engine.
SEBU7833-03
i01930350
NOTICE
NOTICE
Advertisement
Chapters
