Table of Contents
Advertisement
Usage
4.8
Operation
The machine's functions can be controlled using the control panel - see
page
10.
During operation, the operator pushes the grinder forwards over the floor surface.
4.8.1
Standby
To activate the machine's functions, turn the ON/OFF knob to the right. When the knob
is in this position, the green Standby light (DUTY) is lit, indicating that the machine is
in standby mode.
4.8.2
Emergency stop switch
The emergency stop switch, (EM-Stop) must only be used in an emergency.
When the switch is pressed, all electrically-powered equipment on the machine are
turned off.
Note!
Do not use the emergency stop switch to stop the machine other than in
emergencies, as it decreases the lifespan of the machine's electrical
components.
Note!
As long as the emergency stop switch (EM-Stop) is pressed, the machine
cannot be started. Reset by turning the switch 45° so that it pops out again. The
machine can then be restarted.
4.8.3
Starting the machine
For a description of the control panel,
1. Make sure the emergency stop switch is not activated.
2. Insert the cable.
3. Start the dust separator if dry grinding is to be done.
4. Turn the ON/OFF knob to the right.
5. Start the grinding discs rotation, by turning the REW/FWD knob to the desired
direction of rotation.
18
see Figure 3-3, page
10.
HTC 800 Classic
Figure 3-3,
1.0
Hide quick links:
Advertisement
Table of Contents
