Advertisement
SEBU7833-03
Illustration 46
(1) Screw
(2) Element
(3) Glass bowl
(4) Sensor connection
(5) Drain
(6) Bottom cover
1. Place a suitable container below the water
separator.
2. Open the drain (5). Allow the fluid to drain into
the container.
3. When clean fuel drains from the water separator
close the drain (5). Tighten the drain by hand
pressure only. Dispose of the drained fluid
correctly.
Fuel System Secondary Filter -
Replace
Fuel leaked or spilled onto hot surfaces or elec-
trical components can cause a fire. To help pre-
vent possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
This document is printed from SPI². Not for Resale.
Do not allow dirt to enter the fuel system. Thoroughly
clean the area around a fuel system component that
will be disconnected. Fit a suitable cover over discon-
nected fuel system component.
Element filter
Turn the valves for the fuel lines (if equipped) to the
OFF position before performing this maintenance.
Place a tray under the fuel filter in order to catch
any fuel that might spill. Clean up any spilled fuel
immediately.
g01118416
Illustration 47
(1) Drain
(2) Filter bowl
1. Close the valves for the fuel lines (if equipped).
2. Clean the outside of the fuel filter assembly. Open
the fuel drain (1) and drain the fuel into a suitable
container.
i02469473
Maintenance Section
Fuel System Secondary Filter - Replace
NOTICE
71
g01010637
Advertisement
Chapters
