Advertisement
Operation
Driving the machine
The first item to check after starting up the engine is to
ensure that the MAIN POWER SYSTEM READY lamp (1)
is lit (see figure below). This indicates that the voltage and
frequency from the generator are correct, and that the power
can be turned on. The power is turned on by pressing in the
ELECTRIC POWER ON button (2). When the ELECTRIC
POWER ON button has been pressed in, the MAIN POWER
ON lamp (3) lights up.
OFF
ON
Grinding
Speed
OFF
ON
On
Main Power
Off
Warning
HTC 2500 iX
2
3
1
OK
OK
OFF
ON
OFF
ON
OFF
ON
Grinding
Speed
OFF
ON
On
Main Power
Off
Warning
HTC 2500 iX
35
The machine's front wheels are equipped with brakes that
are turned on when the STEERING button is in the OFF po-
sition (see figure below). As long as the button is in this posi-
tion, the machine's wheels remain locked. In order to drive
the machine, check that the control is in neutral position and
set STEERING to the ON position. The machine is now not
braked, which is important to known when e.g. starting on
an incline. Pay attention to the fact that power load AMP-left
or AMP-right will not exceed the recommended power output
OK
OK
OFF
ON
OFF
ON
OFF
ON
Grinding
Speed
OK
OK
OFF
ON
OFF
ON
OFF
ON
Grinding
Speed
OFF
ON
On
Main Power
Off
Warning
HTC 2500 iX
Advertisement
Chapters
