Introduction; About This Document; Supported Hardware And Software; Notes, Cautions, And Danger Notices - Broadcom G610 Hardware Installation Manual

53-1004408-11 Installation Guide

Introduction

About This Document

This hardware installation guide contains procedures and safety requirements for installing the Brocade
into a rack system or as a stand-alone device. Also provided are steps to initially configure the switch for operation, verify
and monitor operation, replace switch field-replaceable units (FRUs), and install transceivers and cables. Complete
technical specifications for the switch are also included.

Supported Hardware and Software

This document is applicable to the Brocade G610 FC Switch running Fabric OS
lists the rack mount kits that are supported with this device.
Table 1: Rack Mount Kits
Part Number
XBR-R000162
XBR-000165
XNA-000072

Notes, Cautions, and Danger Notices

Notes, cautions, and danger statements may be used in this document.
NOTE
A Note provides a tip, guidance, or advice, emphasizes important information, or provides a reference to related
information.
CAUTION
A Caution statement alerts you to situations that can be potentially hazardous to you or cause damage to
hardware, firmware, software, or data.
DANGER
A Danger statement indicates conditions or situations that can be potentially lethal or extremely hazardous to
you. Safety labels are also attached directly to products to warn of these conditions or situations.
Broadcom
Fixed-mount kit for four-post racks.
Mid-mount kit for two-post racks.
Nonport-side fixed-mount rack kit (15 in.—20 in.) for four-post racks.
®
Brocade G610 Switch Hardware Installation Guide
®
(FOS) 8.1.0 or later. The following table
Description
®
G610 Switch
53-1004408-11
6