Broadcom G610 Hardware Installation Manual page 15

53-1004408-11 Installation Guide
Table 4: Installation Prerequisites
Task
Unpack the device.
Gather the necessary components and
required tools.
Review the safety precautions.
Plan the installation.
Review and verify installation
requirements.
Gather network configuration
parameters.
Installation and Initial Configuration
The initial setup includes mounting the device on a flat surface or in a rack and completing the configuration tasks
necessary to bring the device online and verify the operation.
Table 5: Installation and Basic System Configuration
Task
Mount the device.
Gather all components required for the
initial setup.
Broadcom
Task Details or Additional Information
Take an inventory of the hardware components included in your shipment. See
Shipping Carton Contents.
Review the time and items required information at the beginning of each chapter
to ensure that you have gathered all the necessary components that are
required for the following installation tasks:
•
Mounting the Device
•
Installing Transceivers and Cables
See Safety Precautions. For the translation of these messages, see
and Danger Notices.
Decide whether you want to install the unit on a flat surface or in a rack. For
rack installation, obtain the appropriate rack mount kit. See
Verify that the following requirements are met. See
•
Power requirements
•
Environmental requirements
•
Clearance for stand-alone or rack installation
•
IP address:
•
Subnet mask:
•
Default gateway:
•
Domain ID:
•
Time zone:
Task Details or Additional Information
Choose one of the following mounting options:
•
Mount the device as a stand-alone unit. See
•
Mount the device using the slide rack mount kit. See
2U Fixed-Mount Rack Kit for Four-Post Racks
•
Mount the device using the fixed-mount rack kit on four-post racks. See
Installing the 1U and 2U Fixed-Mount Rack Kit for Four-Post Racks (XBR-
R000162).
•
Mount the device using the mid-mount kit on two-post racks. See
the 1U and 2U Mid-Mount Kit for Two-Post Racks (XBR-000165 and XBR-
R000292).
•
Mount the device using the nonport-side fixed-mount rack kit (15"-20") on
four-post racks. See Installing the 1U and 2U Nonport-Side Fixed-Mount
Rack Kit (15 in.–20 in.) for Four-Post Racks (XNA-000072 and
XNA-100072).
See Items Required.
®
Brocade G610 Switch Hardware Installation Guide
Cautions
Mounting Options.
Facility Requirements.
Stand-alone Installation.
Installing the 1U and
(XBR-R000162).
Installing
Completed
Completed
53-1004408-11
15