Preparing For Installation; Safety Precautions; General Precautions; Esd Precautions - Broadcom G610 Hardware Installation Manual

53-1004408-11 Installation Guide

Preparing for Installation

Safety Precautions

When using this product, observe all danger, caution, and attention notices in this manual. The safety notices are
accompanied by symbols that represent the severity of the safety condition.
See "Cautions and Danger Notices"

General Precautions

DANGER
The procedures in this manual are for qualified service personnel.
DANGER
Before beginning the installation, see the precautions in "Power Precautions."
CAUTION
Changes or modifications made to this device that are not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
CAUTION
Make sure the airflow around the front and back of the device is not restricted.
CAUTION
Never leave tools inside the chassis.
CAUTION
To protect the serial port from damage, keep the cover on the port when not in use.
CAUTION
Do not install the device in an environment where the operating ambient temperature might exceed 40°C
(104°F).
CAUTION
The device must be installed only indoors because the Ethernet ports are not TNV-1 compliant and the device,
the AC power adapter, and the cables are not designed for outdoor use.

ESD Precautions

DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
CAUTION
Before plugging a cable into any port, be sure to discharge the voltage stored on the cable by touching the
electrical contacts to ground surface.
CAUTION
Static electricity can damage the chassis and other electronic devices. To avoid damage, keep static-sensitive
devices in their static-protective packages until you are ready to install them.
Broadcom
for translations of safety notices for this product.
®
Brocade G610 Switch Hardware Installation Guide
53-1004408-11
12