Siemens LME7 Series Basic Documentation page 138

<3 s
It will now be displayed for 2 minutes, or can be finished by pressing the
<2
min
or
/reset
Note
During the restore process, all settings and parameters are written from the program module to
the internal memory device of the basic unit. In the process, it is possible that previous program
sequences, parameters and settings in the internal memory device of the basic unit will be
overwritten!
Caution!
On first startup or after exchange of the program module, the sequence of functions and
parameter settings must be checked upon completion of the restore process.
→ Refer to chapter Operation via AZL2... / first startup, restore
→ Refer to chapter Operation via internal LED / first startup, restore
Building Technologies
HVAC Products
Basic Documentation LME7...
19 Operation via the AZL2...
/reset
Press to activate the restore process.
/reset
Display shows run
After approx. 3 seconds (depending on the duration of the
program sequence), the displays shows rSt End and sig-
naled the end of the restore process.
Display: rSt End
↓
The display shows OFF if the restore process is finished.
button
/reset
93/164
CC1P7105en
13.10.2009