Status Indications According To Auma Classification - AUMA SQV 05.2 Operation Instructions Manual

SQV 05.2 SQV 14.2 / SQRV 05.2
ACV 01.2 Non-Intrusive Profibus DP
Pivot point axis
8.2.2.

Status indications according to AUMA classification

SQRV 14.2 Control unit: electronic (MWG)
Figure 50: Indication for setpoint control (positioner)
E1 Position setpoint
E2 Actual position value
The pivot points and their operation behaviour (operation profile) are shown on the
pivot point axis by means of symbols.
The symbols are only displayed if at least one of the following functions is activated:
Operation profile M0294
Timer CLOSE M0156
Timer OPEN M0206
Figure 51: Examples: on the left pivot points (intermediate positions); on the right
stepping mode
Table 16: Symbols along the pivot point axis
Symbol Pivot point (intermediate position)
with operation profile
| Pivot point without reaction
Stop during operation in direction
CLOSE
Stop during operation in direction
OPEN
Stop during operation in directions
OPEN and CLOSE
Pause for operation in direction CLOSE
Pause for operation in direction OPEN
Pause for operation in directions OPEN
and CLOSE
These indications are available if the parameter Diagnostic classific. M0539 is set
to AUMA.
Warnings (S0005)
If a warning has occurred, the display shows S0005:
the number of warnings occurred
a blinking question mark after approx. 3 seconds
Figure 52: Warnings
For further information, please also refer to <Corrective action>.
Indications
Stepping mode
End of stepping mode
Start of stepping mode in direction
CLOSE
Start of stepping mode in direction
OPEN
43