Status Indications According To Auma Classification - AUMA SAEx 07.2 Manual

SAEx 07.2 SAEx 16.2/SAREx 07.2
ACExC 01.2 Intrusive Modbus RTU
8.2.2.

Status indications according to AUMA classification

SAREx 16.2 Control unit - electromechanical
Table 31: Symbols along the pivot point axis
Symbol Pivot point (intermediate position)
with operation profile
| Pivot point without reaction
Stop during operation in direction
CLOSE
Stop during operation in direction
OPEN
Stop during operation in directions
OPEN and CLOSE
Pause for operation in direction CLOSE
Pause for operation in direction OPEN
Pause for operation in directions OPEN
and CLOSE
These indications are available if the parameter Diagnostic classific. M0539 is set
to AUMA.
Warnings (S0005)
If a warning has occurred, the display shows S0005:
the number of warnings occurred
a blinking question mark after approx. 3 seconds
Figure 75: Warnings
For further information, please also refer to <Corrective action>.
Not ready REMOTE (S0006)
The S0006 display shows indications of the Not ready REMOTE group.
If such an indication has occurred, the display shows S0006:
the number of indications occurred
a blinking crossbar after approx. 3 seconds
Figure 76: Not ready REMOTE indications
For further information, please also refer to <Corrective action>.
Fault (S0007)
If a fault has occurred, the display shows S0007:
the number of faults occurred
a blinking exclamation mark after approx. 3 seconds
Indications
Stepping mode
End of stepping mode
Start of stepping mode in direction
CLOSE
Start of stepping mode in direction
OPEN
61