Indications
8.
Indications
8.1.
Indications during commissioning
LED test
Language selection
Startup menu
8.2.
Indications in the display
Status bar
40
SQV 05.2
SQV 14.2 / SQRV 05.2
When switching on the power supply, all LEDs on the local controls illuminate for
approx. 1 second. This optical feedback indicates that the voltage supply is connected
to the controls and all LEDs are operable.
Figure 39: LED test
During the self-test, the language selection can be activated so that the selected
language is immediately indicated in the display. For this, set selector switch to
position 0 (OFF).
Activate language selection:
1.
Display indicates in the bottom line: Language selection menu? 'Reset'
2.
Hold down push button RESET until display of the following text in the bottom
line: Language menu loading, please wait.
Figure 40: Self-test
The language selection menu follows the startup menu.
The current firmware version is displayed during the startup procedure:
Figure 41: Startup menu with firmware version: 05.00.00 xxxx
If the language selection feature has been activated during the self-test, the menu
for selecting the display language will now be indicated. For further information on
language setting, please refer to chapter <Language in the display>.
Figure 42: Language selection
If no entry is made over a longer period of time (approx. 1 minute), the display
automatically returns to the first status indication.
The status bar (first row in the display) indicates the operation mode [1], the presence
of an error [2] and the ID number [3] of the current display indication.
SQRV 14.2 Control unit: electronic (MWG)
ACV 01.2 Non-Intrusive Profibus DP