AUMA SQV 05.2 Operation Instructions Manual page 77

SQV 05.2 SQV 14.2 / SQRV 05.2
ACV 01.2 Non-Intrusive Profibus DP
Please state device type and our order number (see name plate) when ordering spare parts. Only original AUMA spare parts should be used.
Failure to use original spare parts voids the warranty and exempts AUMA from any liability. Representation of spare parts may slightly vary
from actual delivery.
Ref. no. Designation
001.0 Housing
005.0 Drive shaft
005.1 Motor coupling
005.3 Manual drive coupling
006.0 Worm wheel
009.0 Manual gearing
017.0 Torque lever
018.0 Gear segment
019.0 Crown wheel
022.0 Drive pinion II for torque switching
023.0 Output drive wheel for limit switching
024.0 Drive wheel for limit switching
025.0 Locking plate
058.0 Cable for protective earth
070.0 Motor (incl. ref. no. 079.0)
079.0 Planetary gearing for motor drive
155.0 Reduction gearing
500.0 Cover
501.0 Socket carrier (complete with sockets)
502.0 Pin carrier without pins
503.0 Socket for controls
504.0 Socket for motor
505.0 Pin for controls
506.0 Pin for motor
507.0 Cover for electrical connection
525.0 Coupling
539.0 Screw plug
542.0 Handwheel with ball handle
SQRV 14.2 Control unit: electronic (MWG)
Type Ref. no.
Sub-assembly 553.0
Sub-assembly 554.0
Sub-assembly 556.0
556.1
Sub-assembly 557.0
Sub-assembly 558.0
559.0 1
Sub-assembly 559.0 2
560.0 1
Sub-assembly 560.0 2
Sub-assembly 560.1
Sub-assembly 560.2 1
Sub-assembly 560.2 2
Sub-assembly 566.0
Sub-assembly 566.1
Sub-assembly 566.2
Sub-assembly 566.3
Sub-assembly 567.1
Sub-assembly 583.0
Sub-assembly 583.1
Sub-assembly 584.0
596.0
Sub-assembly 612.0
Sub-assembly 614.0
Sub-assembly 627.0
Sub-assembly 629.0
Sub-assembly S1
S2
Designation
Mechanical position indicator
Socket carrier for motor plug/socket con-
nector with cable harness
Potentiometer as position transmitter
Potentiometer without slip clutch
Heater
Blinker transmitter including pins at wires
(without impulse disc and insulation plate)
Electromechanical control unit with
switches, including torque switching heads
Electronic control unit with magnetic limit
and torque transmitter (MWG)
Switch stack for direction OPEN
Switch stack for direction CLOSE
Switch for limit/torque
Switch case for direction OPEN
Switch case for direction CLOSE
RWG position transmitter
Potentiometer for RWG without slip clutch
Position transmitter board for RWG
Cable set for RWG
Slip clutch for potentiometer
Motor coupling on motor shaft
Pin for motor coupling
Retaining spring for motor coupling
Output drive flange with end stop
Screw plug for end stop
EWG position transmitter
MWG 05.03 cover
Pinion shaft
Seal kit, small
Seal kit, large
Spare parts
Type
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Sub-assembly
Set
Set
77