Panel Functions; Actual Signal Display Mode - ABB DCS 600 MultiDrive Operating Instructions Manual

3.3 Panel Functions

Actual Signal
Display Mode
ACT
DCS 600 Operating Instructions
The CDP 312 has four different keypad (operation) modes:
• Actual Signal Display Mode (ACT)
• Parameter Mode (PAR)
• Function Mode (FUNC)
• Drive Mode (DRIVE) for further extensions
This keypad mode will show, depending on the drive´s history:
• Actual Signals
• Faults
• Fault History Logger
If the ACT-key is pressed immediately after initialization the follow-
ing display is shown. If no panel-key of the CDP 312 is touched
within one minute the Actual Signal Display will appear automati-
cally, except when "Status Display" or "Speed Reference Setting"
is active. (see chapter 3.13 and 3.15)
Actual Signal Display
ID-number Control
of the Drive Location
L = Local
= Remote
Statusrow
Actual Signal
Name, value and unit
Cursor shows
the selected row
If a fault occurs in the drive, the Fault Display will appear automati-
cally. This will happen with all other modes as well, except the Drive
Mode is active.
Fault Display
Type of fault or
alarm
To select Fault History Display see chapter 3.8
Fault History Display
1 = last fault
2 = second last fault
. . .
Fault or alarm name
Total time after
the power up
Note: For correct display of the LED bar select always 1.26 to the first
row of CDP 312 (default) and select desired signal at 18.01.
Chapter 3 - Handling of Control Panel CDP 312
Main contactor
Speed
reference status
0 = Open
rpm
I = Closed
 6  \ZW
6/. :+8/  
79>9< =:  \ZW
-98@ -?<  +
I
 6  \ZW
.-= 
 0+?6> 
 8Y 7 -98>
 6  \ZW
 6+=> 0+?6>
 89 7 -98>
>37/$  2 738
Run Status
I = RUN
0 = STOP

0 50
LED bar (NLMD)
first row also used
for LED bar


3 - 3
IV F