Running The Drive; Operational Command Keys - ABB DCS 600 MultiDrive Operating Instructions Manual

3.14 Running the Drive

Operational Com-
mand Keys
Running the DC-
Drive from
the &'3 
M
DCS 600 Operating Instructions
Operational commands can be given from the Control Panel
CDP 312 every time when the status row is displayed. Operational
commands include START and STOP of the the drive, controlling
the main contactor and adjusting the reference.
CAUTION! To be able to give operational commands from the
CDP 312, the selected control location must be the
Control Panel. The control location can be changed
by means of
If
are no longer functioning.
Take care that the drive is engineered to allow opera-
tion with
Control Name of Key
Panel Key
LOCAL /
LOC
REMOTE
REM
START
STOP
ON
OFF
Ensure safety before you start the drive test!
•
Select LOCAL mode (
REMOTE key.
•
Close (switch on) the main contactor by pressing the
•
Start the drive by pressing the
erence value for the motor will now be possible.
•
Direction of rotation can be changed by presetting the opposite
polarity of reference value in case of 4Q drive.
•
Stop the drive by pressing the
to zero speed (depending on the parameter LOCAL STOP
>3 @)
•
Finally open (switch off) the main contactor by pressing the
2))
key.
Chapter 3 - Handling of Control Panel CDP 312
/2&5(0
/2&$/
mode is activated some of the binary inputs
/2&$/
mode.
To select LOCAL (= CDP 312) or REMOTE
(= ext. control system) operation.
Starts the drive, when in LOCAL mode.
Stops the drive, when in LOCAL mode.
Main contactor closing control, when in
LOCAL mode.
Main contactor opening control, when in
LOCAL mode.
= CDP 312) by pressing LOC/
LOCAL
67$57
6723
/2&$/
key to mode.
Function
21
key. Presetting of a ref-
key. Motor will decelerate
key
3 - 17
IV F