3.6 FAULT resetting (RESET)
3.7 EMERGENCY STOP resetting (RESET)
DCS 600 Operating Instructions
Table (continued): Saving of the Parameters to backup memory
Step
Function
6a.
Confirmation of the saving.
Saving procedure is completed
when 0 is displayed.
6b.
To cancel the saving and keep
the original value press any of
the four keys.
The selected Keypad Mode is
entered.
FAULT resetting is possible in both LOCAL and REMOTE mode of
the drive.
Step
Function
1.
To enter the Actual Signal
Display Mode
2.
To RESET the FAULT
Resetting (RESET) of the EMERGENCY STOP function is not
required with DCS 600. If the EMERGENCY STOP command
is cancelled, there will be a self-resetting routine of the corre-
sponding signal. For restart a switch ON command (signal)
with 0 -> 1 edge has to be used.
Chapter 3 - Handling of Control Panel CDP 312
Press key
ENTER
ACT
PAR
FUNC
DRIVE
Press key
ACT
RESET
Display after key is
pressed
È'ÈTÈÈÈÈÈ&$&ÈÈÈ&&
'1ÈF`QdGÈTWIQEÈXC`È
&(È
UWFG
F`QdGÈ
È((ÈÈ
È'ÈTÈÈÈÈÈ&$&ÈÈÈ&&
'1ÈF`QdGÈTWIQEÈXC`È
&(È
F`QdGÈ
UWFG
È&È
È
Display after key is
pressed
È'ÈTÈÈÈÈÈ&$&ÈÈÈ&&
FEaÈ2&&
ÈHCcTbÈ
È0'ÈVWÈUÈEWVb
È'ÈTÈÈÈÈÈ&$&ÈÈÈ&&
TGFÈXCVGÈÈÈÈÈ&$&È
UWbW`ÈaXÈÈÈÈÈ&$&ÈÈ
EWVdÈEc`ÈÈÈÈÈ&$&ÈCÈ
3 - 9
IV F