Selection Of Actual Signals Group 1 - ABB DCS 600 MultiDrive Operating Instructions Manual

3.12 Selection of Actual Signals Group 1 ... 9

DCS 600 Operating Instructions
Note:
The selection of actual signals will remain unchanged even if the
unit is switched OFF and ON again.
Please observe: if the actual signal Parameter is within the soft-
ware part of the SDCS-CON-2 board, the selected actual signal
has to be entered in the Group 94.
Step Function
1. To enter the Actual Signal
Display Mode
2. To select the desired line.
3. To get acces to the desired line.
4. To select a different group.
5. To select a Index.
6. To accept the selection and to
return to the Actual Signal
Display Mode.
Chapter 3 - Handling of Control Panel CDP 312
Press key
ACT
ENTER
ENTER
Display after key is
pressed
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
TGFÈXCVGÈÈÈÈÈ&$&È
UWbW`ÈaXÈÈÈÈÈ&$&È’‡È
EWVdÈEc`ÈÈÈÈÈ&$&ÈCÈ
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
TGFÈXCVGÈÈÈÈÈ&$&È
UWbW`ÈaXÈÈÈÈÈ&$&È’‡È
EWVdÈEc`ÈÈÈÈÈ&$&ÈCÈ
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
'ÈCEbcCTÈdCTcGa
'2ÈEWVdÈEc`ÈCEb
È&$&ÈCÈ
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
(ÈCEbcCTÈdCTcGa
&'ÈTQUQbGFÈaXGGFÈ`GH
È&$&È’‡È
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
(ÈCEbcCTÈdCTcGa
&)ÈaXGGFÈFQHHG`GVEG
È"&$&È’‡È
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
TGFÈXCVGÈÈÈÈÈ&$&È
UWbW`ÈaXÈÈÈÈÈ&$&È’‡È
aXGGFÈFQÈÈÈÈ"&$&ÈÈ
3 - 15
IV F