Saving Of The Parameters To Backup Memory - ABB DCS 600 MultiDrive Operating Instructions Manual

Chapter 3 - Handling of Control Panel CDP 312

3.5 Saving of the Parameters to backup memory

(in case of control board exchange)
3 - 8
IV F
In general all changed Parameters will be saved immediately in the
non-volatile memory. That is why no separate saving is required.
Exception: In case of a control board exchange (SDCS-CON-2/SDCS-
NOTE: For Software downloading observe the relevant instructions given
on the "read_me" file of the corresponding Software disc!
Step Function
1. To enter the Parameter Mode
Selection
2. To select Group 15.
While pressing the arrow down,
only the Group number is dis-
played. When the key is re-
leased, number, name and
value of the first parameter in
the Group is displayed.
3. To select Index 02 from
Group 15.
While pressing the arrow down,
only the signal name and num-
ber are displayed. When the key
is released the value is also dis-
played.
4. For activating press ENTER.
5. To select 22 for saving of
changed values.
Table to be continued!
AMC-DC) the detected hardware coding has to be saved
to the FPROM (backup memory).
Note: For thyristor power converters DCS 600 of size C4
≥ 2050 A).the rated values etc. (Param. [P 42.07]
(I
rated
to [P 42.11]) have to be entered before saving them to
the FPROM; see chapter 2.2 "Scaling intra-unit signals".
Display after key is
Press key
pressed
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
')ÈQ%WÈaGbbQVIaÈ
&'ÈCVÈQVÈbCEPÈPQÈdCT
PAR
È)&&&&
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
'1ÈF`QdGÈTWIQEÈXC`È
&'ÈUCQVEWVbÈEWVÈUWFG
È
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
'1ÈF`QdGÈTWIQEÈXC`È
&'ÈUCQVEWVbÈEWVÈUWFG
ÈWV
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
'1ÈF`QdGÈTWIQEÈXC`È
&(È
F`QdGÈ
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
'1ÈF`QdGÈTWIQEÈXC`È
&(È
F`QdGÈ
È&È
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
'1ÈF`QdGÈTWIQEÈXC`È
&(È
F`QdGÈ
ENTER
Èi&q
È'ÈTÈÈÈÈÈ&$&È’‡ÈÈ&&
'1ÈF`QdGÈTWIQEÈXC`È
&(È
F`QdGÈ
Èi((q
DCS 600 Operating Instructions
UWFG
UWFG
UWFG
UWFG