Chapter 3 - Handling of Control Panel CDP 312
3.13 Drive Mode
Table: Symbols of Status Display
3 - 16
IV F
Display of the ID-number for the Drive and for the Control Panel CDP 312
as well as display of the status (Status Display):
Step
Function
1.
To enter the Drive Mode
2.
To select the Status Display (see
table below):
To change the ID number of the
drive (the ID-Number will appear
in brackets) and then ...
to select the new value.
To accepted the new value.
The power of the DCS 600 must
be switched OFF to validate its
new ID-Number setting (the new
value is not displayed until the
power is switched OFF and ON).
The Status Display of all drives
connected to the Panel Link is
shown after the last individual
drive.
If all drives do not fit on the dis-
play at once, press the arrow
keys to show the rest of them.
3.
To cancel the Drive Mode.
The selected Keypad Mode is
entered.
Symbol
o
Stopped, main contactor OFF (open)
p
Stopped, main contactor ON (closed)
n
Running, main contactor ON (closed)
0
Alarm or fault signalling effective in the drive
Press key
Display after key is
FEaÈ2&&
QF"VcUDG`ÈÈÈ'
DRIVE
bWbCTÈÈ'&ÈF`QdGa
FEaÈ2&&
QF"VcUDG`ÈÈÈi'q
bWbCTÈÈ'&ÈF`QdGa
ENTER
ENTER
p
È'
È( È) È0 È1
p
È2 È3 È4 È5 È'&
ACT
PAR
FUNC
DRIVE
Status Display
DCS 600 Operating Instructions
pressed
n
o
n n
0
n n n