Speaker Volume Level; Adjusting The Speaker Volume - Viavi Seeker X User Manual

Speaker volume level

While testing for leaks, you may need to adjust the volume of the leakage tone.
Use the VOLUME button to adjust the
volume. The bar graph at the bottom
will show the level.

Adjusting the speaker volume

To check the volume of the leakage tones, press the VOLUME
button. The speaker icon displays.
Press VOLUME again to adjust the level. There is no sound
y
for the adjustment, the bar graph shows the level instead,
as shown here.
When leaks are found, you will hear the volume change in
the leakage tone.
The display continues to show the RF signal level as you
y
adjust.
You can also press and hold the volume button to quickly increase the volume and
y
lower it again.
NOTE:
The display will revert to the signal level display after a few
seconds in the speaker volume level display (without any
action by the user).
Feb 2020
Seeker X User's Guide
22137808, Rev. 001
Chapter 2 Using Your Seeker X
GPS DIST PK FREQ
NOISE
dB
μV
m
SEEKER X
GPS DIST
Speaker volume
PK FREQ
NOISE
dB
μV
m
SEEKER X
47