Enable/Disable Peak Hold - Viavi Seeker X User Manual

Enable/Disable peak hold

To enable/disable the Peak Hold function, turn your Seeker X on and press the SELECT
button repeatedly until the arrow appears under the PK icon, as shown here.
When the Peak Hold display is selected, pressing the
y
disable the Peak Hold function.
When this display is selected, the following will occur:
y
If the Peak Hold function is currently disabled, the PK icon flashes with the
y
arrow below the icon.
If the Peak Hold function is currently enabled, only
y
the arrow below the PK icon flashes.
NOTE:
The display will revert to the signal level display after a few
seconds in the peak hold display (without any action by the
user).
When the Peak Hold function is enabled, the following will occur in the Signal Level
y
display:
The PK icon is constantly displayed at the top of the
y
screen.
The numerical display holds the latest peak RF level
y
reading for up to five seconds, unless the RF level
increases. This is useful if you are not able to look at
the display immediately or if you want to confirm
the highest level reading.
The peak element of the bar graph at the bottom
y
of the display also holds its peak indication for five
seconds, while the other elements of the bar graph
continue to indicate the signal strength of the live signal.
Feb 2020
Seeker X User's Guide
22137808, Rev. 001
Chapter 2 Using Your Seeker X
CHANGE button will enable/
GPS DIST PK
Peak hold disabled
GPS DIST PK
Peak hold enabled
FREQ
NOISE
dB
μV
m
SEEKER X
FREQ
NOISE
dB
μV
m
SEEKER X
41