Preset Frequency Toggle - Viavi Seeker X User Manual

Preset frequency toggle

To quickly toggle within the selected frequency plan:
1. Press the CHANGE button to show the current preset setting.
2. Press the CHANGE button repeatedly to quickly toggle through the frequencies.
When first entering the preset frequencies display or after selecting a new preset, the
following will occur:
The display will show the primary frequency on the top
y
line, as shown here. The second frequency in the plan will
be displayed on the second line.
After a few seconds, the display will change to show the
y
tag for both the first and second frequencies.
The remaining information for the first two presets
y
will be displayed on subsequent screen changes until
complete and then repeat the steps above for the
remaining frequencies in the plan, if there are any (up to
4 total frequencies).
When the display has cycled through the information
y
for all of the enabled frequencies in the selected plan
(if selected), the display will resume RF signal level
measurement of the selected preset frequencies.
NOTE:
In this example, the first frequency in the plan 1 is 138 MHz,
Tag 2.
NOTE:
The display will revert to the signal level after a few
seconds in the presets display (without any action by the
user).
Feb 2020
Seeker X User's Guide
22137808, Rev. 001
Chapter 2 Using Your Seeker X
Preset frequency
Tag selection
43