About The Battery Of Your Seeker X; Usb Charging - Viavi Seeker X User Manual

Chapter 1 Quick Tour

About the battery of your Seeker X

The Seeker X uses Lithium-Ion batteries. The batteries are not charged during manufacture and
should be fully charged prior to using the first time for best results.
Lithium-Ion batteries operate differently than Nickel-Cadmium batteries. They should be
charged daily, and should not be deeply discharged as this could damage the battery. There is
no memory effect and concerns about charging too soon or with little use are unwarranted.

USB charging

You can charge the Seeker X outside of the Mobile Mount using the following charging
methods:
Connecting the Mini-USB cable and charger from an AC power source to the Seeker
y
X. The Mini-USB charge / data cable and charger must be connected to both the
Seeker X and a working power outlet before AC charging can begin.
Connecting the Mini-USB vehicle cable and charger from the vehicle power jack
y
to the Seeker X. The Mini-USB charge / data cable must be connected to both the
Seeker X and vehicle power jack before USB charging can begin.
The following conditions apply when charging the Seeker X via USB:
If the Seeker X is turned back on when USB charging, the Measurement mode is
y
disabled while the Seeker X is USB charging.
When the Seeker X is on and charging, the Charge icon
y
flashes, and the bar graph shows the charging progress, as
shown here.
30
Seeker X User's Guide
22137808, Rev. 001
GPS DIST PK FREQ
NOISE
dB
μV
m
SEEKER X
Feb 2020