Table of Contents
Advertisement
Chapter 2 Using Your Seeker X
Data synchronization with Seeker MCA III (optional)
If you do not have a network connection for LAW uploads when using the Seeker X with
the Seeker MCA III, the data recorded in the Seeker MCA III can be synchronized with the
internal memory of the Seeker X for later upload through a PC.
NOTE:
Data synchronization will only work when the Seeker X is in
the Mobile Mount. The SNAPSHOT button is used to record
leakage information recorded by the Seeker X when it is
not in the Mobile Mount.
To synchronize the data between the Seeker MCA III and the
Seeker X, press and hold the SNAPSHOT button until SYNC
appears. While the Seeker MCA III is transferring data to the
Seeker X, the screen shown in the image to the right will be
displayed.
IMPORTANT:
The bar graph will show the progress of the data
synchronization, do not remove the Seeker X from the
Mobile Mount until the data synchronization is completed,
otherwise data corruption (although unlikely) may occur.
When the Seeker MCA III is done transferring data to the
Seeker X, the screen shown in the image to the right will
be displayed. Press any button to return to the RF Signal
Measurement display.
50
Seeker X User's Guide
22137808, Rev. 001
GPS
DIST
PK
FREQ
NOISE
dB
μV
m
SEEKER X
Syncronization progress
GPS
DIST
PK
FREQ
NOISE
dB
μV
m
SEEKER X
Synchronization done
Feb 2020
Advertisement
Table of Contents
