Selecting A Frequency - Viavi Seeker X User Manual

Chapter 2 Using Your Seeker X

Selecting a frequency

The Preset Frequencies display is used to select the RF signal level measurement frequency
plan used by the Seeker X. The preset frequencies 1–4 can be configured using the Mobile
Tech application, StrataSync, or Seeker Setup software.
NOTE:
For detailed instructions on how to set the frequency plans
and their associated tag settings, see the
Seeker Setup Software User's
Press the CHANGE button to toggle through the enabled presets (1–4).
To select a frequency plan, press the SELECT button repeatedly until FREQ flashes at the
top of the display.
First 3 digits for first 2
frequencies
The display will show the 1st frequency in the plan on line 1, with the 2nd frequency
y
on line 2. It only shows the first 3 digits of the frequency for each, at first.
After a few seconds, the display shows the remaining 4 digits for both frequencies.
y
The signal type is then displayed, followed by the tags for those frequencies.
y
The remaining information for the first two presets will be displayed on subsequent
y
screens until complete and then repeat the steps above for the remaining
frequencies in the plan, if there are any (up to 4 total frequencies).
Possible attributes you might see (depending how frequencies are configured
y
in Seeker Setup: Chirp, Dual, and sub channel spacing.
For OFDM signals, you may also see screens for cyclic prefix (CP).
y
When the display has cycled through the information for all of the enabled
y
frequencies in the selected plan (if selected), the display will resume RF signal level
measurement of the selected preset frequencies.
42
Guides.
Last 4 digits for those
frequencies
Seeker X User's Guide
22137808, Rev. 001
StrataSync or
Frequency attributes
Feb 2020