Using Your Seeker X; Viewing The Battery Charge Level - Viavi Seeker X User Manual

Chapter 2 Using Your Seeker X

Using your Seeker X

While testing for leaks, you will need to view the information shown by the Seeker's display
modes.
Use the SELECT button to toggle
y
through its display modes. As you
toggle, the display modes will
appear in the same order in which
they are discussed in this section.
Use the CHANGE button to adjust
y
the settings of some display
modes. Also toggles frequency
presets from the measurement
screen (press once to view, twice to
change).

Viewing the battery charge level

To check the battery level, turn your Seeker X on and press the SELECT button once.
When the battery charge level display is selected, the Battery icon flashes as shown
y
here.
When this display is selected, the following will occur:
y
The bar graph will indicate the amount of battery
y
charge available. As long as there are at least a
few bars left, your Seeker X has enough charge to
operate.
If the battery meter shows less than 50%, the
Seeker X should be charged.
The numerical display will continue to display the
y
RF signal level.
NOTE:
The display will revert to the signal level display after a few
seconds in the battery charge level display (without any
action by the user).
38
Seeker X User's Guide
22137808, Rev. 001
GPS DIST PK FREQ
NOISE
dB
μV
m
SEEKER X
Battery charge level
Feb 2020