Changing The Parameter Setting Value - Mitsubishi Electric 700 Series Instruction Manual

Operation panel
5.1.3

Changing the parameter setting value

Changing
Change the Pr. 1 Maximum frequency setting.
example
Operation
1.
Screen at power-ON
The inverter starts up in the Network operation
mode.
The monitor display appears.
2.
Change the X12 signal (Bit11) setting to "1."
X12 signal (Bit11) gives a control input
command through FL remote communication.
3.
Press to choose the PU operation mode.
4.
Press to choose the parameter setting
mode.
5.
Turn until
6.
Press to read the currently set value.
" "(120.0Hz (initial value)) appears.
7.
Turn to change the set value to
" " (60.00Hz).
8.
Press to set.
Turn
Press
Press
Press
REMARKS
,
appears .................... Write disable error
appears .................... Write error during operation
appears .................... Mode designation error
(For details, refer to page 194.)
The number of digits displayed on the operation panel is four. Only the upper four digits of values can be displayed and set. If the
values to be displayed have five digits or more including decimal places, the fifth or later numerals can not be displayed nor set.
(Example) For Pr. 1
When 60Hz is set, 60.00 is displayed.
When 120Hz is set, 120.0 is displayed and second decimal place is not displayed nor set.
76
(Pr. 1) appears.
to read another parameter.
to show the setting again.
twice to show the next parameter.
twice to return the monitor to frequency monitor.
is displayed...Why?
or
PU indicator is lit.
PRM indicator is lit.
(The parameter number read previously appears.)
Flicker...Parameter setting complete!!
Display