Table of Contents
Advertisement
8.
Install the oil-filler cap into the filler neck and the
dipstick into the dipstick tube
9.
Start the engine and check for oil leaks.
10.
Shut off the engine, wait 2 to 3 minutes, remove
the dipstick, and check the oil level in the engine.
Note:
If needed, remove the oil-filler cap, add
the specified oil to bring the oil level to the full
mark on the dipstick, and install the oil-filler cap.
11.
Install the dipstick, engine heat shield, and tilt
the seats down.
Checking the PCV Valve
Service Interval: Every 1,000 hours
1.
Tilt the driver's seat forward and align the prop
rod into the detent in the prop-rod-guide slot.
2.
Remove the PCV valve from the fitting of the
valve cover
(Figure
Note:
Do not separate the hose from the PCV
valve.
Figure 82
1. Front of the machine
2. Hose (crankcase
ventilation)
3.
Shake the PCV valve.
Note:
If the internal restrictor of the valve
rattles, the PCV valve is serviceable; if the
internal restrictor is not free to rattle when
shaken, replace the PCV valve
4.
Insert the PCV valve until it is fully seated in the
seal for the valve-cover fitting
5.
Lower the operator's seat.
(Figure
81).
82).
3. PCV valve
4. Valve-cover fitting
(Figure
82).
(Figure
82).
Performing Yearly Engine
Maintenance
Service Interval: Every 400 hours/Yearly (whichever
Complete all yearly maintenance procedures specified
in the engine owner's manual.
g028345
61
comes first)
Advertisement
Table of Contents
