Delta Electronics ASDA-A Series User Manual page 57

Call 1(800)985-6929 for Sales
Chapter 3 Connections and Wiring|ASDA-A&A+ Series
DI
Signal
MD0
MD1
MDP0
MDP1
JOGU
JOGD
STEPU
STEPD
STEPB
AUTOR
GNUM0
GNUM1
INHP
STF
STB
Footnote *2: The "state" of the input function may be turned ON or OFF as it will be dependant on the
settings of P2-10~P2-17.
3-24
Call 1(800)985-6929 for Sales
Assigned
Pin No.
DI
Control
Code
(Default)
Mode
33 Pr -
34 Pr -
35 Pr -
36 Pr -
37 ALL -
38 ALL -
39 Pr -
40 Pr -
41 Pr -
42 Pr -
Pt, Pr, Pt-S,
43 -
Pr-S
Pt, Pr, Pt-S,
44 -
Pr-S
45 Pt, Pt-S -
S, Sz, Pt-S,
46 -
Pr-S, S-T
S, Sz, Pt-S,
47 -
Pr-S, S-T
deltaacdrives.com
Details
Feed step mode input 0 (bit 0)
Feed step mode input 1 (bit 1)
Manually continuous operation
Manually single step operation
Forward JOG input. When JOGU is
activated, the motor will JOG in forward
direction. [see P4-05]
Reverse JOG input. When JOGD is
activated, the motor will JOG in reverse
direction. [see P4-05]
Step up input. When STEPU is activated,
the motor will run to next position.
Step down input. When STEPD is
activated, the motor will run to previous
position.
Step back input. When STEPB is
activated, the motor will return to first
position.
Auto run input. When AUTOR is activated,
the motor will run automatically according
to internal position command. For time
interval setting, please see P2-52 to P2-
59.
Electronic gear ratio (Numerator) selection
0 [See P2-60~P2-62]
Electronic gear ratio (Numerator) selection
1 [See P2-60~P2-62]
Pulse inhibit input. When the drive is in
position mode, if INHP is activated, the
external pulse input command is not valid.
Enable motor forward operation. In speed
mode, it is used to enable the motor
forward operation.
Enable motor reverse operation. In speed
mode, it is used to enable the motor
reverse operation.
deltaacdrives.com
sales@deltaacdrives.com
Wiring Diagram
(*2)
(Refer to 3.3.4)
C9/C10
Revision April 2009
sales@deltaacdrives.com