Speed Integral Compensation; Speed Feed Forward Gain - Delta Electronics ASDA-A Series User Manual

Call 1(800)985-6929 for Sales
P2 - 06 KVI
Default: 100
Applicable Control Mode: ALL
Unit: N/A
Range: 0 ~ 4095 (ASDA-A series)
Settings:
This parameter is used to set the integral time of speed loop. When the value of speed integral
compensation is increased, it can improve the speed response ability and decrease the speed
control deviation. However, if the setting value is over high, it may generate vibration or noise.
P2 - 07 SFG
Default: 0
Applicable Control Mode: ALL
Unit: 0.0001
Range: 0 ~ 20000
Settings:
This parameter is used to set the feed forward gain when executing speed control command.
When using speed smooth command, increase gain can improve speed track deviation.
When not using speed smooth command, decrease gain can improve the resonance condition of
mechanical system.
In theory, stepping response can be used to explain proportional gain (KVP), integral gain (KVI) and
feed forward gain (KVF). Now we use frequency area and time area respectively to explain the logic.
Frequency Domain
Revision April 2009
Call 1(800)985-6929 for Sales
deltaacdrives.com
Chapter 6 Control Modes of Operation|ASDA-A&A+ Series

Speed Integral Compensation

0 ~ 1023 (ASDA-A+ series)

Speed Feed Forward Gain

deltaacdrives.com
sales@deltaacdrives.com
Communication Addr.: 0206H
Related Section:
Section 6.3.6
Communication Addr.: 0207H
Related Section:
Section 6.3.6
sales@deltaacdrives.com
6-23