Attach Support Legs To Ramps - EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Manual

Hide thumbs Also See for PATHWAY HD Code Compliant Modular Access System:

Table of Contents

3.3. ATTACH SUPPORT LEGS TO RAMPS

3.3.1. Install the support leg bracket, included in the CONNECTOR – RAMP TO RAMP, on the

3.3.2. Install the provided 5/16" flat washers and 5/16"-18 nylon insert locknuts onto the

3.3.3. Level the support leg bracket, using a bubble level or similar tool, and then torque the

FIG. 3.7

PATHWAY HD Code Compliant Modular Access System Installation Manual

center studs of the center saddle bracket. The round hole goes over the upper stud

and the curved slot over the lower stud (FIG. 3.6).

studs (FIG. 3.6) but do not tighten fully until the bracket has been leveled.

two 5/16"-18 nylon insert locknuts to 20 ft.-lbs. (FIG. 3.7).

FIG. 3.6

Page 18 of 92

Table of Contents

Do you have a question about the PATHWAY HD Code Compliant Modular Access System and is the answer not in the manual?