EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Manual page 43

5.4.3. Locate the appropriate barrier attachment plate. If the upper end of the ramp or ramp
5.4.4. Fasten barrier attachment plate to the lowermost hole in the 1-1/2" square x 42-7/16"
5.4.5. Attach upper rail of picketed guard closure to closure post using a 5/16"-18 x 2-1/4"
5.4.6. Drill holes in the ramp side rail and attach the barrier attachment plate to the side
PATHWAY HD Code Compliant Modular Access System Installation Manual
run terminates at a platform, use the "up sloping" version of the plate. If the lower
end of a ramp or ramp run starts at a platform, use the "down sloping" version. Note
the orientation of the larger 3/8" diameter hole with respect to the 1-1/2" x 2" section
of the plate as shown (refer back to FIG. 5.3) to identify which barrier attachment
plate is needed.
long closure post and lower rail of the picketed guard closure using a 5/16"-18 x 3"
long hex bolt and 5/16" flat washer with the guard closure spacer between the barrier
attachment plate and the closure post.
5.4.4.1. Orient the closure post with the two holes which are the closest together
on top. If the uppermost hole in the closure post does not align with the
uppermost hole in the platform angle post, the closure post is upside
down. Make sure the leg of the attachment plate with the two smaller
holes is captured under the upper hook and in contact with the ramp side
rail. Move the ramp or platform slightly (if needed) and clamp the
attachment plate to the side rail if possible before drilling (FIG. 5.14).
hex bolt and 5/16" flat washer though the second hole from the top of the closure
post (FIG. 5.14).
rail in the same manner described in 'CLOSURES' section and shown (refer back to
FIG. 5.5).
FIG. 5.14
Page 43 of 92