Table of Contents
Advertisement
Quick Links
PATHWAY® Low Profile
Platform
Supplement
This supplemental document is intended to be used alongside the PATHWAY® Modular
Access System Assembly Manual.
LIFETIME WARRANTY. Please register at www.ezaccess.com/warranty-satisfaction.
© EZ-ACCESS®, a division of Homecare Products, Inc. All rights reserved.
All text and images contained in this document are proprietary and may not be shared, modified,
distributed, reproduced, or reused without the express written permission of EZ-ACCESS.
Manufactured in the USA
17706 12-08-17
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for EZ-ACCESS PATHWAY
Summary of Contents for EZ-ACCESS PATHWAY
- Page 1 PATHWAY® Low Profile Platform Supplement This supplemental document is intended to be used alongside the PATHWAY® Modular Access System Assembly Manual. LIFETIME WARRANTY. Please register at www.ezaccess.com/warranty-satisfaction. © EZ-ACCESS®, a division of Homecare Products, Inc. All rights reserved. All text and images contained in this document are proprietary and may not be shared, modified, distributed, reproduced, or reused without the express written permission of EZ-ACCESS.
- Page 2 INTRODUCTION The PATHWAY® Modular Access System includes Low Profile Platforms which are only 1-9/16” thick (tall) as compared to standard platforms which are approximately 3-1/2” thick (tall). Throughout this document, the PATHWAY® Low Profile Platform may also be referred to as the Low Profile Platform, or Platform.
- Page 3 Use caution at all times. Proper maintenance and upkeep to the Platform and all system components is vital. The term “system” refers to the entire PATHWAY Modular Access System, including any gates, stairs, ramps, platforms, risers, handrails, supports, transition plates, landing pads, and any/all hardware and components which are intended to be assembled on the PATHWAY Modular Access System.
- Page 4 1.1. INSTALL PLATFORMS: It is strongly suggested that all platforms and ramps be installed before installing handrails (see ‘HANDRAILS’ in the main PATHWAY® Modular Access System Manual). 1.1.1. There are three types of platforms (one or more of these platform arrangements may be used in an installation).
- Page 5 ‘ANGLE RAMPS WITH RESPECT TO PLATFORMS, PORCHS, OR DECKS’ in the main PATHWAY® Modular Access System Manual instead of this section. 2.1. Locate the MRHPLP (RAMP HANGER PAIR LOW PROFILE). Install two hangers onto the side of the platform where the ramp will be attached.
- Page 6 Do not attempt to walk on ramps until installation is complete. 2.4. Proceed with the system installation as described in the main PATHWAY® Modular Access System Manual and secure all ramps to platforms as described in the ‘Ramp End Clip Installation Instructions Addendum’...
- Page 7 INSTALL PLATFORM HANDRAILS 3.1. Platform handrail assembly for Low Profile Platforms is the same as standard Platforms. Refer to ‘HANDRAILS’ in the main PATHWAY® Modular Access System Manual and assemble the handrails in the manner appropriate for the desired configuration.
Need help?
Do you have a question about the PATHWAY and is the answer not in the manual?
Questions and answers