EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Manual page 19

3.3.4. Locate the appropriate PHDSLxxPR SUPPORT LEG PAIR (where "xx" denotes the leg
3.3.5. Place a foot under the support leg bracket with the foot extending under the ramp,
3.3.6. After the support leg is fully engaged in the foot, tighten the 3/8"-16 headless socket
3.3.7. Tighten the foot's thumb screw securely.
3.3.8. Insert a plug into the top of each support leg. Use a rubber mallet or similar tool to
PATHWAY HD Code Compliant Modular Access System Installation Manual
length) for the location.
and then insert a 1-1/2" support leg through the support leg bracket into the foot.
Loosen the two set screws in the support leg bracket and the foot's thumb screw, if
needed, to fully engage the support leg in the foot (FIG. 3.8).
If installing on soft soil it may be necessary to set the foot on a concrete pad.
set screws in the support leg bracket to 15 ft.-lbs. (FIG. 3.8).
Do not attempt to walk on the ramps until all support leg set screws have
been tightened as specified.
fully seat as needed. If necessary, use construction adhesive to bond the plug in place.
FIG. 3.8
Page 19 of 92