EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Manual page 53

5.6.16. Install another 2-15/16" ring joiner into the other ends of the elbows. Orient joiner
5.6.17. Loosen the elbow assembly screws and align the opposing faces of the elbows
5.6.18. Measure gap between faces of opposing rings of the 2-15/16" ring joiners (FIG. 5.27).
5.6.19. Cut the 1-1/2" diameter tube to the length measured. Using a metal file, remove any
5.6.20. Install the cut 1-1/2" diameter round tube between the 2-15/16" ring joiners.
5.6.21. Securely tighten adjustable elbow assembly screws and all ring joiner set screws.
FIG. 5.26
FIG. 5.27
PATHWAY HD Code Compliant Modular Access System Installation Manual
set screw toward the underside of ramp handrail (FIG. 5.26).
shown, and then tighten elbow assembly screws and joiner set screws enough to
hold the components in position (FIG. 5.26 and FIG. 5.27).
5.6.18.1. Make sure the faces of the opposing rings of the 2-15/16" ring joiners are
parallel before measuring or cutting the 1-1/2" diameter tube.
sharp edges from cutting.
Remove and reinstall the adjustable elbows, if needed (FIG. 5.27).
Page 53 of 92