Two-Line Rail Barrier And Mid Rail - EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Manual

Hide thumbs Also See for PATHWAY HD Code Compliant Modular Access System:

Table of Contents

5.2. TWO-LINE RAIL BARRIER AND MID RAIL

5.2.1. The 1.5" x 2" barrier will come in the length required for the platform side and should

5.2.2. Insert 1-1/2" square threaded inserts into both ends of the barrier (FIG. 5.2). Use a

5.2.3. Attach the lower 1.5" x 2" barrier in the lowermost hole in the platform angle post

5.2.4. Locate the appropriate barrier attachment plate (FIG 5.3). If the upper end of the

FIG. 5.2

FIG. 5.3

PATHWAY HD Code Compliant Modular Access System Installation Manual

not need to be trimmed.

rubber mallet or similar tool to fully seat as needed.

using a 5/16"-18 x 1" long hex bolt (do not use a flat washer at this location). The 1.5"

x 2" barrier is commonly installed with the larger cavity (into which the 1-1/2" square

threaded insert is installed) on top and the smaller cavity on the bottom (FIG. 5.2).

ramp or ramp run terminates at a platform, use the "up sloping" version of the

plate. If the lower end of a ramp or ramp run starts at a platform use the "down

sloping" version. Note the orientation of the larger 3/8" diameter hole with

respect to the 1-1/2" x 2" section of the plate as shown (FIG. 5.3) to identify the

barrier attachment plate needed.

Page 36 of 92

Table of Contents

Do you have a question about the PATHWAY HD Code Compliant Modular Access System and is the answer not in the manual?