Secure Ramps To Platforms - EZ-ACCESS PATHWAY HD Code Compliant Modular Access System Installation Manual

6.2. SECURE RAMPS TO PLATFORMS

6.2.1. Once installation of ramps, platforms, handrails, connectors, and closures are
6.2.2. Position each ramp end clip with the hole pointing up and oriented as shown (FIG. 6.2),
6.2.3. Before the ramp end clip contacts the ramp side rail, rotate the ramp end clip so the
6.2.4. Use the hole in the ramp end clip as a template to drill 1/8" pilot hole in the platform
6.2.5. FIG. 6.4 shows the top view of the completed end clip installation.
6.2.6. Repeat this process for all locations where a ramp meets a platform.
FIG. 6.2
PATHWAY HD Code Compliant Modular Access System Installation Manual
complete and all fasteners and set screws have been tightened, secure ramps to
platforms with ramp end clips (included in RAMP HANGER PAIR).
Use two ramp end clips at all locations where ramps meet platforms.
then insert the short end of the ramp end clip into small gap between the ramp and the
platform in the area where the ramp side rail overlaps the ramp end tread.
short end extends into the recess under the ramp end tread (FIG. 6.2).
side rail, and then use the 1/4" x 1" long self-drilling screws to secure the ramp end
clip to the platform side rail (FIG. 6.3).
FIG. 6.3 FIG. 6.4
Page 75 of 92