EZ-ACCESS Titan Series Installation Manual

Commercial ramp system

Advertisement

Installation Manual
ADDENDUM
7' & 8' Platform, Legs, Guards, & Handrail Installation
This addendum covers the special requirements for installing platform, legs, guards and handrail components
for the 5' x 7' and 5' x 8' Titan Series Commercial Ramp System. For additional instructions, refer to the main
manual titled Titan Series Commercial Ramp System Installation Manual.
Read and follow all instructions/warnings prior to assembly and use. To obtain a copy of complete
instructions, warnings, and cautions please call 1-800-258-8503.
Load rating: 100 lbs. psf live load, 300 lbs. concentrated.
Consult factory for any assembly configuration not covered in this addendum.
Do NOT use if ramp is damaged or unstable.
CAUTION: Refer to your equipment's (wheelchair or scooter) Owner Guide for the proper degree
of incline/decline and chair direction before attempting ramp use. Never exceed its
recommendations.
IMPORTANT: Use ramp only with a qualified helper.

1. INSTALLING PLATFORM LEGS:

1.1
Legs for the 5' x 7' platform (Fig. 1a) are installed in the same manner as the 5' x 5' and 6' x
6' platforms. Refer to the main manual titled Titan Series Commercial Ramp System
Installation Manual.
1.2
The 5' x 8' platform has two additional legs that must be installed at the midpoint of the 8'
side. Install all six legs in the platform, set the platform at the desired height, and tighten the
eight setscrews in the corner pockets securely. Refer to the main manual titled Titan Series
Commercial Ramp System Installation Manual for additional information.
1.3
For the two legs installed in the "center" pockets, do not tighten the setscrews until after
the guard has been installed (Fig. 1b).
1.4
If the leg is in a location that will be unguarded or on the ramp side of a platform, mark the leg
at the top of the center pocket, lift the leg up, cut the top of the leg off approximately 1/8"
below the mark and drop the leg back into place (Fig. 2 & 3).
Fig. 1a (5x7 Platform)
Commercial Ramp System
Fig. 1b (5x8 Platform)
TITAN SERIES

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Titan Series and is the answer not in the manual?

Questions and answers

Summary of Contents for EZ-ACCESS Titan Series

  • Page 1 This addendum covers the special requirements for installing platform, legs, guards and handrail components for the 5’ x 7’ and 5’ x 8’ Titan Series Commercial Ramp System. For additional instructions, refer to the main manual titled Titan Series Commercial Ramp System Installation Manual.
  • Page 2 8’ side of the platform (Fig. 4). The 7’ and 8’ filler sections are installed adjacent to ramps in the same manner as the 5’ & 6’ filler sections depending on the configuration. Refer to the main manual titled Titan Series Commercial Ramp System Installation Manual.
  • Page 3 The handrails on the outside of 5’ x 7’ and 5’ x 8’ turn platforms are returned to a guard in the same manner as the 5’ x 5’ and 6’ x 6’ platforms. Refer to the main manual titled Titan Series Commercial Ramp System Installation Manual for installation instructions.
  • Page 4 5’ x 5’ and 6’ x 6’ platforms. Connect the 90° elbows to the ramp handrail using ring joiners as shown in Fig. 37 in the main manual titled Titan Series Commercial Ramp System Installation Manual.

This manual is also suitable for:

Addendum

Table of Contents