Step By Step Configuration - Loma IQ2 Service Manual

STEP BY STEP CONFIGURATION

There are circumstances where it may be necessary for the end user to carry
out the commissioning procedure for the control unit. Typically, this would occur
when LOMA do not have enough information about the end application, such as
the belt speed or reject details, too fully configure the machine. There are, in
addition, other instances such as performing a software update, moving the
detector to a different application, replacing a control card, etc. By following
through the step by step configuration guide the unit can easily be set up from
scratch as required. Alternatively, if only small changes are required to the
configuration of the machine, then the menu entries within the Service menu can
individually be adjusted.
information.
At the start of this chapter is a menu map for the Service menu upon which
configuration details for the machine can be recorded. We suggest that you fill
this in when you configure the system, then if ever a need to repeat the exercise
occurs all the information will be ready to hand.
We also suggest that you record all product related data, then if ever a need to
reprogram the detector occurs, for instance if a control board is replaced all the
information will be ready to hand.
Module 7026
Configuration and Set up Information
Refer to your User Manual for detailed menu
5-4