Aastra 470 System Manual page 170

Installation
Terminal selection
Two system phones can be connected to a DSI interface (DSI-AD2 only). The system
can only differentiate the two system phones by the position of the address switch
on the phone. The following settings are possible (TSD = Terminal Selection Digit):
• TSD1
• TSD2
Note:
In the following cases Not Configured is displayed along with the node
number, the slot number and the port number. In this state the system
phone is not ready for operation:
– A terminal has been created at the connected port, but the address
selection switch is incorrectly set.
– No terminal has yet been created at the connected port.
User allocation
In the configuration each terminal is assigned to a user or a free seating pool. If a
terminal has been created at the connected port and the address selection switch
is correctly selected but no user or free seating pool is allocated to the terminal, the
system phone display reads
the system phone is not ready for operation.
Terminal type
The terminal type is specified along with the configuration of the system. when the
lines are also assigned to the line keys.
Note:
If the terminal type configured is incorrect, the system phone display
shows the warning Wrong phone type. On the Office 10 the LED flashes
slowly. In this situation, although the system phone can be used for basic
telephone operations, none of the added features will be available. The
terminal type must be entered via the AMS Configuration Manager or on
the terminal via login to the system configuration.
Carrying out a logon on the system phone:
– Office 10: Press the Foxkey twice.
– All other system phones: Long keypress (long click) on a function key.
Set new phone type appears next. Confirm with Foxkey Yes.
170
No Number and indicates the terminal ID. In this state
Aastra 470 ab R3.0
syd-0337/1.5 – R3.0 – 05.2013