Aastra 470 System Manual page 168

Installation
Status LED
The status of the Ethernet interfaces is indicated by the green and yellow LEDs di-
rectly on the interface in question.
Fig. 70 Status LED on the Ethernet interfaces
Tab. 76 Status LED on the Ethernet interfaces
Green LED Yellow LED
On On
flashing flashing
On Off
flashing Off
Off On
Off flashing
Cable requirements
Use commercial Cat. 5 cable, or choose a cable type with the following characteris-
tics:
Tab. 77 Requirements for an Ethernet cable
Core pairs  cores
Stranded
Wire diameter, core
Screening
Category
See also:
Informations about the on the Ethernet interface can be found on the
applications card in the Installation Instructions for the CPU2 application
card.
168
Rate State
10 Mbit/s Port has a connection with the network
10 Mbit/s Port is receiving or sending data
100 Mbit/s Port has a connection with the network
100 Mbit/s Port is receiving or sending data
1 Gbit/s Port has a connection with the network
1 Gbit/s Port is receiving or sending data
4  2
yes
0.4...0.6 mm
yes
Cat. 5 minimum
Aastra 470 ab R3.0
syd-0337/1.5 – R3.0 – 05.2013