Keithley 6482 Reference Manual page 112

Dual-channel picoammeter / voltage source
Table of Contents

Advertisement

Model 6482 Dual-Channel Picoammeter / Voltage Source Reference Manual
Figure 8-6
Trigger link connections
CA UTION:
CHANNEL 1
Step 5. Set trigger input line to #2.
Select #2 and then press the ENTER key three times to return to the CONFIGURE TRIG-LAYER
menu.
Step 6. Set trigger output line to #1.
1. Select TRIGGER-OUT and then press the ENTER key.
2. Select LINE and then press the ENTER key.
3. Select #1 and then press the ENTER key.
Step 7. Set trigger out events to MEAS=ON (all others to OFF).
1. Select EVENTS, and then press the ENTER key.
2. Set MEAS=ON (toggle the value to ON using the EDIT
3. Make sure SOURCE=OFF and DELAY=OFF (set if necessary).
4. Press the ENTER key, and then press the EXIT key to return to the CONFIGURE TRIG-LAYER
menu.
Step 8. Set trigger count to 10.
1. Press the EDIT
press the ENTER key.
2. Set the count to 10, and then press the ENTER key.
6482-901-01 Rev. A / August 2012
Model 7001 or 7002 Switch System
WARNING:
WARNING:
WARNING:
NO INTERNAL OPERA
NO INTERNAL OPERA TO R SER V ICABLE PART S, S ER VICE BY QU ALIFIED PERSONNE
NO INTERNAL OPERA TO R SER V ICABLE PART S, S ER VICE BY QU ALIFIED PERSONNE
TOR SER VICABLE P
ARTS, SER V ICE BY QU ALIFIED PERSONNEL ONL
MADE IN USA
CA UTION:
FOR CONTINUED P
CA UTION:
RO TECTION A GAINST FIRE HAZARD
, REPLA CE FUSE WITH SAME TYPE AND R AT ING
FOR CONTINUED P
FOR CONTINUED P
RO TECTION AGAINS T FIRE HAZARD
RO TECTION AGAINS T FIRE HAZARD
,REPLA C E FUSE WITH SAME TYPE AND RA TING.
,REPLA C E FUSE WITH SAME TYPE AND RA TING.
Trigger
link connector
Trigger
link connector
WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
INPUT
MADE IN
RATINGS MAX.
U.S.A.
30 V @ 20mA
OUTPUT ENABLE
RATINGS MAX.
COMMON
MODE
200V
CHANNEL 2
RS-232
!
TRIGGER LINK
CAT
I
LINE RATING
50, 60Hz
ANALOG
60 VA MAX
OUT
FUSE
LINE
RATINGS MAX.
30 V @ 20mA
630 mAT
100 VAC
(SB)
120 VAC
!
VOLTAGE
315 mAT
220 VAC
SOURCE
(SB)
240 VAC
OUT
30 V @ 20mA
CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
Model 6482
key to scroll to the end of the menu selections and select COUNT, and then
Return to
L ONL Y.
L ONL Y.
Y.
IN
OUT
.
Trigger
link cable
(Model 8501)
SERIAL NO.
IEEE-488
(CHANGE IEEE ADDRESS
WITH FRONT PANEL MENU)
Section Topics
Section 8: Triggering
key).
8-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

6482 e

Table of Contents