Table of Contents
Advertisement
Programming
Using PARTNER Voice Messaging
System Programming
The System Manager's mailbox (Mailbox 0) is a special mailbox that is used to
program PARTNER Voice Messaging. The System Manager uses this mailbox to:
Reinitialize passwords for mailboxes 01–04 if a subscriber forgets the
password.
Change the System Manager's password for the System Manager's
mailbox (0).
Assign PARTNER communications system extensions to mailboxes 01–04.
Record a menu prompt (up to two minutes long).
Assign Selector Codes (that is, the first digit the caller dials in response to
the menu prompt).
The factory-set password for the System Manager's mailbox is 1234. See
"Changing the System Manager's Password," later in this chapter, for instructions
on how to change the password.
NOTE:
Although the System Manager's mailbox has a password, it does not have
storage capacity for messages.
Logging Into System Administration
To log into System Administration:
1. Call PARTNER Voice Messaging by pressing i777 or a
programmed Voice Mail Auto Dial button.
The system plays: "Please enter extension and #."
2. Press 0 followed by # .
The system plays: "Enter password and #."
3. Enter the four-digit password followed by #. (The factory-set
password is 1234.)
The system plays: "To assign a mailbox to an extension,
press 1. To record the Automated Attendant Menu Prompt,
press 3. For Selector Code assignments, press 4. To
change your password, press 5. To initialize a mailbox,
press 6. To re-initialize a mailbox password, press 7."
NOTE:
The first time you access this menu, you should change the factory-set
password. Use a hard-to-guess value, and record it in a safe place. See
"Changing the System Manager's Password," later in this chapter.
4-4
Issue 1 August 1998
Advertisement
Table of Contents
